###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ######  
         

 ______  
(  ___ \ 
| (   ) )
| (__/ / 
|  __ (  
| (  \ \ 
| )___) )
|/ \___/ 
         

       
/'\_/`\
|     |
| (_) |
| | | |
(_) (_)
       
       

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

  _   _ 
 | | | |
 | | | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaSubaru Start]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassa%2FQuestionsSubaru Questions ]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaInjectorSubaru Injector] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaIgnitionSubaru Ignition] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaTriggerSubaru Trigger] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaDisplaySubaru Display] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaWboSubaru Wbo] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaConfigSubaru Config] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaTableSubaru Table] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassawiringSubaru Wiring]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaIdleSubaru Idle] || ---- Can you update this page ? Trigger measurements and updated trigger config/notes should be on this page (not on main page, especially not in chronological order). Delete outdated info to make it possible to get overview of the uptodate setup. We scoped the oe dwell time, and that is 3ms. http://img.photobucket.com/albums/v41/Denmark/NewFile_07.jpg ** Now cranking 200 RPM (OK), ** car runs fine, when it is started, only cranking is out of sync ** but sometimes backfires during cranking? ---- '''Crank and camsensor signal scopeshot''' - looks OK. VR (LM1815 input) triggering on falling edge of the EC36/27 and EC18/12 http://img.photobucket.com/albums/v41/Denmark/Subarutriggerpicture.jpg Also measure DC voltage of both triggers (engine off, but ignition on). * EC36/27 ... DC measurement: ... V (primtrig sensor: 1.9k Ohm) * EC18/12 ... DC measurement: ... V (sectrig sensor: 1.9k Ohm) ---- link to trigger : http://www.cauzzi.it/coupe/adaptronic/subaru_6_7_timing_chart.gif ---- '''This subaru legacy is running the 6/7 trigger setup''' as it seems no one have had this running with a VEMS yet, i hope to have some help setting this up, I will, then document it,so it will be pnp for other users. D.10/7-2008 :This is the current setting. Firing order 1-3-2-4 ---- primary_trigger=29 secondary_trigger=59 tooth_wheel=02 trigger_tooth=00 another_trigger_tooth=03 crank_minper=BC tooth_wheel_twidth1=00 tooth_wheel_twidth2=00 cam_sync_r_edge_phase=00 cam_sync_f_edge_phase=00 reset_engphase_after=04
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.