##    
         
  ###    
   ##    
   ##    
  ####   
         

  ____  
 |  _ \ 
 | |_) |
 |  _ < 
 | |_) |
 |____/ 
        
        

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

   ___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassa Start]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassa%2FQuestions Questions ]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaInjector Injector] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaIgnition Ignition] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaTrigger Triger] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaDisplay Display] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaWbo Wbo] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaConfig Config] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaTable Table] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassawiring Wiring]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSkassaIdle Idle] || LCD header soldering issue I have been making a V3.3 , and have made a mistake with the LCD connector, I had first put in a plug connector,but unsoldered it again to put the wires in direct, but now there is nothing to solder at, It´s pin1 at the board,(pin9 DB9 cable). According to GenBoard/BuildProcedures/LCDconnect this is the RS (preferred white wire) signal. Please make a photo so we can verify (you know that the 2 leftmost pins on the 2x6pin header). For the RS signal, you just connect to the pin4 of the S259 chip (74HC259), damn easy, right at the pad you ripped, you just blank the wire 2 mm longer and reach the chip pin. Just make sure not to make more damage, use solderer with suitable tip.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.