# ###   
 ##   #  
 #       
 #       
 #       
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

###      
 ## ###  
 ## #    
 #####   
 ## ##   
 ##  ##  
#### ### 
         

         
         
 ######  
  ##  ## 
  ##  ## 
  #####  
  ##     
 ####    

  _  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSeppoRepo Main]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSeppoRepo%2FSensors Sensors] || '''30.05.2004''' :*- Powered up my Genboard 3.0 :*- Tried communication with serial cabel :*- Connected LCD :*- Connected Ps2 Keyboard '''13.07.2006''' :*- Soldering rest of the parts. Hopefully get engine running this summer. (2 years has past, no progress to anything until now!) '''15.11.2006''' :*- I bought H-Profile Conrods, Wild Street cam and had Cylinder Head fully ported (flows 180 HP). :*-Crankshaft is going to be stroked 3mm to get 89 mm stroke. :*-Pistons are going to be Custom pistons from Wiseco. :*-Engine Displacement is going to be 2.1 litre. '''15.01.2007''' :*- Uploaded new firmware from [VemsMT1.0.53.zip] :*- Tried to set Battery Voltage constant with MegaTune, but even with 255 it shows too little. '''16.01.2007''' :*- Changed one BatCal divider resistor 100K/20K -> 100K/39K , with 152 MegaTune shows 0.02V more than my Voltage meter, so i left it there. :*- Map sensor shows zero on Megatune. Measured voltage while putting pressure/vacuum the sensor. Sensor is OK! Tomorror i try to figure out what's the problem. Requiring to change the voltage divider in order to obtain a proper reading sounds a bit strange to me, i would suspect an adc reference voltage problem, i recommend checking and applying the changes listed on the last section of BuildProcedures/SectionThree (v3.2 notes also applies to 3.0) - DB
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.