_   _ 
( ) ( )
| | | |
| | | |
| \_/ |
`\___/'
       
       

 #       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSeppoRepo Main]|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSeppoRepo%2FSensors Sensors] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FSeppoRepo%2FEngine Engine] || '''30.05.2004''' :*- Powered up my Genboard 3.0 :*- Tried communication with serial cabel :*- Connected LCD :*- Connected Ps2 Keyboard '''13.07.2006''' :*- Soldering rest of the parts. Hopefully get engine running this summer. (2 years has past, no progress to anything until now!) '''15.11.2006''' :*- I bought H-Profile Conrods, Wild Street cam and had Cylinder Head fully ported (flows 180 HP). :*-Crankshaft is going to be stroked 3mm to get 89 mm stroke. :*-Pistons are going to be Custom pistons from Wiseco. :*-Engine Displacement is going to be 2.1 litre. '''15.01.2007''' :*- Uploaded new firmware from [VemsMT1.0.53.zip] :*- Tried to set Battery Voltage constant with MegaTune, but even with 255 it shows too little. '''16.01.2007''' :*- Changed one BatCal divider resistor 100K/20K -> 100K/39K , with 152 MegaTune shows 0.02V more than my Voltage meter, so i left it there. :*- Map sensor shows zero on Megatune. Measured voltage while putting pressure/vacuum the sensor. Sensor is OK! Tomorror i try to figure out what's the problem. Requiring to change the voltage divider in order to obtain a proper reading sounds a bit strange to me, i would suspect an adc reference voltage problem, i recommend checking and applying the changes listed on the last section of BuildProcedures/SectionThree (v3.2 notes also applies to 3.0) - DB L2 is installed and AVCC(pin 64) shows 5V soadc ref is OK! I forgot to upload config, which caused all the trouble. Everything seems to be OK for now! '''21.04.2008''' :*- Uploaded new firmware from [VemsMT1.0.73.zip] :*- Installed 60-2 Flywheel and VR sensor, Triggering Works OK! since RPM shows on LCD. Next task is wasted spark.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.