###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ######  
         

 __          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

         
    ###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have a new unassembled GenBoard that I havent got working at all yet. Done so far: Soldered EC36 and EC18, EC18-pins14&15 to MAX232, all necessary output drivers and lastly the inductor 1R5 (from the rescue kit). Connected the board to a JimStim 1.3 (http://www.jbperf.com/JimStim/index.html) EC36-Pins5,21,22,26,32 to JimStim accordingly, EC36-Pin25 also to JimStim, EC18-pins14&15 to serial cable, serial GND to common groud point between GenBoard and JimStim. At this point I tried to get first connection with GenBoard. Tried several methods to connect but didn't get any answer. Loopback tested my serial port successfully. To be sure that board is powered I measured the MAX232 and the processors Vcc voltage which was high as 10volts. And that is my problem at the moment.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.