##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 #####   
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Westfield 4.6 Rover V8 (VEMS EFI) Car Spec *1997 Westfield Seight (S8) *Big alloy radiator *4 Pot alloy billet front calipers with drilled & grooved discs *2 Pot alloy billet rear handbrake calipers *Green Stuff Brake Pads *Aluminium Front Wheel Hubs *3.92 rear 7ins ford LSD differential *Ford Cosworth T5 gearbox *Tilton Concentric Slave Cylinder *Toyo R888 tyres (205x50x15) *Protec alloy dampers all round (350lbs front & 275lbs rear) *Westfield Sports Seats *Westfield Contoured Dash *Westfield Boot Box *Westfield Hood https://vgy.me/NoOsBq.jpg https://vgy.me/dIAPwY.jpg https://vgy.me/4Cv3Ss.jpg Engine Spec *Rover V8 4600cc (S46D) *Stage 4 cylinder heads *Double Valve Springs *Act Carbon Fibre Plenum (71mm inlet) *Polished & ported 48mm inlet manifold *Polished & ported 48mm trumpet base (Aluminium Shorted Trumpets) *Thermal Plenum Spacer *Piper 285 camshaft *Billet Rocker Posts *Steel rockers (Fed Mogel) *Gems Roller Timing Chain *Serpentine front end & oil Pump *Modified Throttle Housing (71mm) *Trap door lowered & Baffled sump *Gems flywheel with rear pickup (36-1 trigger & 80deg BTDC) *Magnecor 8mm plug leads *Rhodes lifters *Crane adjustable pushrods *220cc Bosch "Red Devil" Injectors *10.1 Compression Ratio *Varley Red Top 30 Battery *Poly Engine Mountings https://vgy.me/Sd5NFp.jpg Vems ECU Spec *Genboard V3.3 (V1.2.38 Firmware) *400kpa map sensor *20x4 LCD dash display *4 wire stepper motor *1off Throttle Switch *2off knock sensors *1off MAT Sensor *1off Coolant Sensor *1off Cam Sensors (Hall) *1off Crank Sensor (VR) *2off Bosch lambda sensors (LSU4.2) *1off EGT thermocouple (type K) *4 coils (wasted spark) *Bosch Fuel Injection Pump *Bosch 3 Bar Fuel Regulator *Oil Pressure Output *Tachometer Output *Vems External Memory Card *External GPS Logging On 2nd Serial Port *Bluetooth Adapter & Android App https://vgy.me/WJQSJD.jpg Winter 2010 Upgrades included * ACT carbon fibre plenum chamber, which required cutting & welding the original land rover GEMS efi throttle housing to an adpater plate to make it fit the plenum, so i could use the throttle switch and idle motor, this way the wiring was as my original aluminium plenum. Picture here of welded & fitted item. https://vgy.me/LWPny5.jpg https://vgy.me/sUZV2x.jpg https://vgy.me/GhkoC1.jpg * next mod was to install & fit a GPS sensor to use for data logging to the VEMS ECU, i bought a evermore GM-700A reciever as this uses RS232 DB9 connection and outputs NMEA data, extactly what the VEMS needs, to power the unit i installed a PS2 connection in to the VEMS backplate. Picture of wiring & GPS installation. https://vgy.me/NEt51y.jpg 2011 Upgrades * Installation of second knock channel (0) to ecu, as ecu came with only channel 1 installed and for V8 2 channels are required. * Proper rolling road tuning (when engine has done enough miles) currently engine only done about 340miles since rebuild. * Full camsync using either a modified front camshaft sporket or using orginial land rover GEMS efi sprocket. https://vgy.me/zAqJgi.jpg https://vgy.me/Ep1URe.png 2013 Upgrades *Bosch "Red Devil" EV6 Injectors (220cc) *Westfield Sports Seats *Westfield Harnesses https://vgy.me/KO14cN.jpg https://vgy.me/vtb8Jv.jpg 2014 Upgrades *Bluetooth serial adapter for mobile phone datalogging while driving. https://vgy.me/QGKBCN.jpg 2015-2018 Upgrades *Top hatted Block *Pocketed Pistons (Valve Cutouts) *Full dynamic Engine Balance *Ford Cosworth T5 Gearbox (Rebuilt) *Westfield T5 Propshaft *Tilton Concentric Slave Cylinder *Tilton Clutch Master Cylinder *Gems roller timing chain *10.1 Compression Ratio *Cometic Head Gaskets https://vgy.me/zQ6Aro.jpg https://vgy.me/XQLLAR.jpg https://vgy.me/TPI4BB.jpg https://vgy.me/YjFlzd.jpg 2018 and on *Run new rebuilt engine & gearbox in for 500 miles, then look to proper tune ECU on rolling road for optimum performance. More pictures can be found here. https://vgy.me/album/nTGV9Fu1
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.