___   
(  _`\ 
| | ) |
| | | )
| |_) |
(____/'
       
       

  _    _ 
 | |  | |
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ###  ## 
         

  _      
 | |     
 | |     
 | |     
 | |____ 
 |______|
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
||MembersPage/Sascha||MembersPage/Sascha/CorradoRthritytwo|| Having issue with secondary trigger and getting cam angles to work out. I'm a little stuck with setting up camshaft control, I can get the car to run on sec trigger settings that seems to place the cam shafts @ 90 deg, of course this is outside of the acceptable window for control (of 5-35 deg) on both cams according to the software. If I move the edge from Rising to Falling it lowers the cam positions from 90 to 45 deg, but then I get trigger errors for not enough secondary triggers (engine runs fine though). I've tried shifting to other secondary cam tooth locations, but all I get is pops in the exhaust... do you think I need to shift the ignition and inj events to make this work or am I looking at this all wrong? sorry first time setting up a somewhat complicated dual cam setup. It's a MK4 VW R32 engine, so it has the following cam gear pickups: http://www.vems.hu/files/MembersPage/Sascha/CorradoR32/DSC05808.jpg Here are trigger logs: http://www.vems.hu/files/MembersPage/Sascha/CorradoR32/v3.3_u011107-2016-08-20-14.13.21.triggerlog http://www.vems.hu/files/MembersPage/Sascha/CorradoR32/v3.3_u011107-2016-08-20-14.16.35.triggerlog CFG of running w/ cam sync - rising edge ECU showing cam angle @ 90 deg): http://www.vems.hu/files/MembersPage/Sascha/CorradoR32/R32-ID1000-NA_CAMS_rev2.vemscfg Complete log of running car and various attempts of moving the cam sync to another tooth: http://www.vems.hu/files/MembersPage/Sascha/CorradoR32/v3.3_u011107-2016.08.20-14.25.36.vemslog
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.