##    
         
  ###    
   ##    
   ##    
  ####   
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

 ###     
  ##     
  ##  ## 
  ## ##  
  ####   
  ## ##  
  ##  ## 
         

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I started to solve new firmware problems to ver2. Only few new ifdefs is needed so firmware compiles. I haven't tested these but if someone could confirm my changes so it doesn't break anything else. I made these changes to mt-RC2 packet. for comm.c <code> uint8_t getMCPdataHIGH(uint8_t i) { uint16_t t; uint8_t r = 0; #ifdef GENBOARDv3 //add this if(i < 8) { t = mcp3208_data[i]; if (t != 0xffff) // r = (uint8_t) t >> 8; r = t >> 8; } #endif // add this return r; } </code> <code> uint8_t getMCPdataLOW(uint8_t i) { uint16_t t; uint8_t r = 0; #ifdef GENBOARDv3 //add this if(i < 8) { t = mcp3208_data[i]; if (t != 0xffff) r = (uint8_t) t & 0xFF; read_mcp3208(i); } #endif //add this return r; } </code> for fuel calc.c <code> void fill_all_squirters(uint16_t pw) { .... // TODO: check if gcc adds sizeof... } while(i); #ifdef GENBOARDv3 //add this #ifdef INJECTOR_STAGING // Calculating pulsewidth of secondary injectors uint16_t pw2; if(engine.tps >= config.inj_stage2_start_tps && engine_kpa8() >= config.inj_stage2_start_map) pw2 = mult16_16(pw, (uint16_t)(config.inj_stage2_rate) + 256)>>8; // effectively (256 + 256) / 256 else pw2 = 0; i=SECONDARY_INJ_CHANNELS_NUM; while(i) { i--; cli(); inj_port_p->pwm_delay = t; inj_port_p->pwcalc = pw2; sei(); inj_port_p++; // TODO: check if gcc adds sizeof... } #endif // calculate injector bitmask used when firing all injectors simultaneously i = config.alternate & 0x0f; mask = injport_map(i); while(i) { i--; mask |= injport_map(i); } engine.injector_bitmask = mask; #endif //add this } </code> --- Show me where to get latest working and tested ver2.2 firmware that compiles cleanly.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.