____ 
  / ___|
 | |    
 | |___ 
  \____|
        

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 #####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have no luck with o2 sensors :) Bosch wbo2 sensor ( p/n: 0 258 017 030/031, VW 06E 906 265C ) It looks like "17 025" sensor ( http://wbo2.com/lsu/sensors.htm ), and the pinout is the same. It is likely to be an LSU4.9 sensor (not the same pinout as LSU4.2). I found some info on http://www.vems.hu/wiki/index.php?page=WideBand page. The problem is that I can't do the free-air calibration. The highest o2 value was ~18% while the wbo2 calibration constant was 255... What config (or HW) changes should I try ? Everything is the factory recommended settings. Pump zero pw, and nernst target values are ok. I'm afraid that I'll kill the sensor... ---- **OLD** NBO2 Config taken from here: http://www.vems.hu/manual/html/ch09s07.html but on test bench MT reads (fast changing) random voltage (2-5V). *The NBO2 input is the 2nd nernst channel that is pin EC18-1, not EC18-13 (not correct in manual) **Found the cause of the problem(?): There is a squre wave at the ADC7 input, it is coming from OC2 pin (atmega pin 17) thru C62 and R137. ---- The truth is, noone used nbo2 sensor for 4 years. To start the engine it's not needed. To tune the engine it's not suitable. *I know, I just want to move on with the project, because I dont know when the wbo2 sensor arrives (I bought one from ebay). So everyone just sells nbo2 sensor and swaps to wbo2, the only reasonable way. If you can start the engine, don't tune before you have WBO2. It does not worth the risks. You can checkout order via IBAN and pay later. (note: wbo2 sensor hasn't been sent, as you were hesitating and said hold until you ask owner. Orders must go through webshop, not phone anyway) *Sorry, but this must be a misunderstanding. I ordered the sensor on ebay before I made the order for the genboard in the webshop. ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.