_____ 
 |_   _|
   | |  
   | |  
  _| |_ 
 |_____|
        
        

 ###     
  ##     
  ##  ## 
  ## ##  
  ####   
  ## ##  
  ##  ## 
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 #####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Distributor based ignition, it needs logic drive, it is connected to stepper A. * ''Stepper A'' is channel 3. See GenBoard/Manual/DigitalOut/Table . So channel 0 is bad for stepper A. ** I don't understand why it is bad. **For example**: h[2]=36 46 56 66 00 00 00 00 . When genboard makes an ignition event, and the ignition outputs are set to 03..00, then the first impulse will go to that output that the 03 element of the h[2] table defines (=0x66=stepper D), the next impulse goes to 0x56=Stepper C, then 0x46=stepper B, and finally 0x36=stepper A. Is this right? **With distributor, all of the impulse should go to the same output, so every (used) element in h[2] should be the same? Factory dwell is about 3-4mS. http://www.vems.hu/files/RudolfFeher/ign_settings.jpg http://www.vems.hu/files/RudolfFeher/ign_settings2.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.