######  
## ## ## 
## ## ## 
## ## ## 
## ## ## 
## ## ## 
         

  _____
 |__  /
   / / 
  / /_ 
 /____|
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
|\     /|
( \   / )
 \ (_) / 
  ) _ (  
 / ( ) \ 
( /   \ )
|/     \|
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
++**VEMS v3.3 running 1.0.73 fw**++ It will be built in using the original wires and sensors. **++About the engine:++** Primary trigger: missing tooth, 60-2, bosch VR sensor (polarity checked) Secondary trigger: hall (not used yet) Knock sensing will be used later Narrow band o2 (help needed with this) One coil with distributor Bosch IAC (pwm drive) 115kPa MAP sensor No EGT Fire order: 1-3-4-2 440cc high-Z injectors with high voltage flyback **++Config:++** MembersPage/RufolfFeher/IgnitionSetup MembersPage/RufolfFeher/InjectionSetup **++Future TODO:++** Change nbo2 to wbo2 Throw out the distributor, and replace with wasted spark coils or COP **++Questions:++** **--How to set up the NBO2?** Config taken from here: http://www.vems.hu/manual/html/ch09s07.html but on test bench MT reads (fast changing) random voltage (0-5V). It does not matter whether the sensor is connected or not. When I changed the Setting-Constants to WB in MT, it stuck at 0V.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.