#    
 ######  
   ##    
   ##    
   ##    
   ## #  
    ##   
         

  ______ 
 |  ____|
 | |__   
 |  __|  
 | |____ 
 |______|
         
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
 ######  
## ## ## 
## ## ## 
## ## ## 
## ## ## 
## ## ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
++**VEMS v3.3 running 1.0.73 fw**++ It will be built in using the original wires and sensors. **++About the engine:++** Primary trigger: missing tooth, 60-2, bosch VR sensor (polarity checked) Secondary trigger: hall (not used yet) Knock sensing will be used later Narrow band o2 (help needed with this) One coil with distributor 115kPa MAP sensor No EGT Fire order: 1-3-4-2 440cc high-Z injectors with high voltage flyback **++Config:++** MembersPage/RufolfFeher/IgnitionSetup MembersPage/RufolfFeher/InjectionSetup **++Future TODO:++** Change nbo2 to wbo2 Throw out the distributor, and replace with wasted spark coils or COP **++Questions:++** **--How to set up the NBO2?** Config taken from here: http://www.vems.hu/manual/html/ch09s07.html but on test bench MT reads (fast changing) random voltage (0-5V). It does not matter whether the sensor is connected or not. When I changed the Setting-Constants to WB in MT, it stuck at 0V.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.