|\ /| ( \ / ) \ (_) / \ / ) ( | | \_/
______ | _ \ | | | | | | | | | |/ / |___/
_____ (_ _) | | | | | | (_)
_______ ( ____ \ | ( \/ | (_____ (_____ ) ) | /\____) | \_______)
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''VEMS on a Volvo V70N 5cyl engine''' Please have a look at my homepage: http://www.hilmersson-racing.com (Swedish) The project page: http://www.hilmersson-racing.com/start.asp?show=e '''Specs:''' * 5cyl, 2.4L * 60-2 cranktrigger, VR sensor. Note: Missing '''tooth''', not missing '''gap''' * 1 pulse on cam, HALL sensor * Ignition with active coil's directly on the spark plugs. ---- '''Questions:''' '''Ignition''' * The active coils on this engine needs +5V signal as trigger. The GenBoard has 2 IGBT + 6 logic-level outputs. Is the logic level outputs always +5V? '''Injection''' * How do I set the injection end angle? I mean the angle in crank degrees when the injector is activated. This should be when the inlet valve is open (at lower loads) '''Trigger''' Are these config settings correct for this engine setup with 60-2 trigger? *primary_trigger=01 *secondary_trigger=18 *tooth_wheel=3A *trigger_tooth=05 *another_trigger_tooth=18 *tooth_wheel_twidth1=02 *tooth_wheel_twidth2=06 Is this a better solution?: To make a new trigger wheel with only 5 teeth. One trigger teeth for each cylinder. *primary_trigger=01 *secondary_trigger=18 *tooth_wheel=05 *trigger_tooth=01 *another_trigger_tooth=02 *tooth_wheel_twidth1=02 *tooth_wheel_twidth2=48 ---- Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.