###    
     #   
  ####   
 #   #   
  ### #  
         

         
|\     /|
| )   ( |
| |   | |
( (   ) )
 \ \_/ / 
  \   /  
   \_/   
         

         
         
 # ###   
 ##   #  
 #       
 #       
 #       
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

 #       
 #       
 #   #   
 #  #    
 # #     
 ## #    
 #   #   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
''Volvo 244 -82'' http://www.vems.hu/files/RobinJohansson/my_car.JPG 4 cyl, 16v, B234 block filled and O-ringed, forged pistons from ford probe 2.3L, forged H-profile rods, A cheap Super T70 turbo with Semi ballbearings, 60.5mm compressor inlet, 0.84 exhaust, WB lamda, GM 3bar map sensor, 4*960cc injectors, 44mm wastgate, own manifold, own exhaust manifold, lage truck intercooler and VEMS v3.1 board with serial number: 1st bord: 87 (2nd 99) BMW 535 (getrag 260) gearbox converted to fit volvo. ---- '''Page TODO''' Keep a clean page! ---- '''Current working on''' get it running... '''Valued tip''' Back to tabletests: apply lightbulbs or LEDs on outputs, and see OnlineCourse/OffEngineTesting mst63 msp01 (or up to msp7E for lowest RPM) can be used to generate stimulator-output on (stolen) config.act_wot_channel output that can be fed back to self (primary trigger) or to another board - with a series cap if LM1815 is used. ---- '''Trigger wheel''' http://www.vems.hu/files/RobinJohansson/trigger.JPG Bosch VR sensor (jetronic), 36-1, mounted at crank. Trigger wheel is a castiron, 36-1 with a teethwide of 4mm->4.5deg and 5mm~>5.5deg jumps, missing tooth 14mm~>15.5deg ---- '''Fuel setup''' || cyl || inj || EC36pin # || h[0] # || || 1 || A || 7 || 01 || || 2 || F || 18 || 20 || || 3 || G || 6 || 40 || || 4 || H || 17 || 80 || h[0]=80 40 20 01 00 00 00 00 h[1]=00 00 00 00 00 00 00 00 ---- '''Ignition setup''' 2 ign banks, firering a Ford dual coil with 4 outputs (Wastefire) || cyl || Driver || EC36pin # || h[2] # || || 1+4 || 06 || 24 || 06 || || 2+3 || 05 || 12 || 05 || h[2]=06 05 06 05 00 00 00 00 ---- Updated 2005-08-01 My tables http://www.vems.hu/files/RobinJohansson/tables.txt My config http://www.vems.hu/files/RobinJohansson/config.txt ---- '''My V3.1 board:''' http://www.vems.hu/files/RobinJohansson/robin%20v3.1%20out.JPG
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.