###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

 _____ 
/  __ \
| /  \/
| |    
| \__/\
 \____/
       
       

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

 _____ 
|  _  |
| | | |
| | | |
\ \/' /
 \_/\_\
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Building a BMW M10 racecar engine''' ---- '''Engine specifications''' * 4-cylinder 2 valves/cylinder engine. * 2058 cc normally aspirated. * Rebuilt head with optimized intake and exhaust ports. * Special cast intake manifold. * TWM 45 mm throttlebodies. * 304 Dr. Schrick camshaft. * BMW S14 rods and custom made JE pistons. Total newbie on VEMS, but gets lots and lots of help from Johan Rius (Thanks a lot!!) ---- '''Questions to Rikard''' As we spoke earlier you were thinking of going with a distributorless setup, is it using: * the missing tooth trigger wheel and wasted spark coils -or- * using a cam sync sensor and separate coils for direct fire ? In either case you can still use the missing tooth wheel as the crank sensor (primary trigger) for a more accurate engine speed. If you're going for a direct-fire setup, the easier trigger arrangement would be cutting of all but two teeth from the 36-1 wheel you have and use the Honeywell GT1 Hall sensor. These two teeth should pass the sensor about 60 degrees before TDC, i.e. place the sensor and then determine what teeth to keep. ---- Q: Thinking about using the Honeywell GT1 Hall-sensor, but my toothweel has a smaller "tooth spacing" and "target thickness" than the GT1-sensor needs according to its specifications. Is it possible to use it anyway since I´m not even close to the 100kHz its supposed to handle? 8000 rpm is less then 5kHz with 36 teeth triggerwheel.. A: I guess you would have to try. With a multi tooth setup it's easy to watch the count of the wheel errors to determine if you have trigger sensor (or signal) problems. I know it's not very polite to rev the engine up to 8000 rpm in neutral as there is no load on the engine but it's the fastest way to find out if there is trouble. Any errors and it should appear in the wheel error count on page 2 of the LCD display as a kind of rev limiter as ignition (and fuel? don't remember) is cut when the Genboard looses track of the wheel tooth count. Here is good reading for finding any trouble: InputTrigger/TriggerLog Specifications: http://www.elfa.se/images/highres/h20086.jpg ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.