#####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

  _____ 
 | ____|
 |  _|  
 | |___ 
 |_____|
        

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

  _____ 
 |_   _|
   | |  
   | |  
   |_|  
        

 _   _ 
| | | |
| |_| |
|  _  |
| | | |
\_| |_/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
After using piggyback ECU's such as Morristech TSI and AEM Fic 6/8 and not satisfied, I decided to go standalone ECU. Engine code: S50B32 Specs: 6 cylinder in line Infinite variable camshaft angle on both intake and exhaust(VANOS) displacement (cm3): 3201 JE pistons 8.5:1 compression ratio Forged ARROW connecting Rods Coil on plugs and full sequential Stock cams GT37/40 hybrid turbo Engine management: VEMS V3.6 Firmware 1.1.96 Dual Vanos Enabled VEMSTUNE 1.2.4 I kept the OEM harness and sensors to have the installation clean and OEM like. First difficulty is the ignition coils wiring: I did not understand the way the ignition outputs are sequenced. The table is traversed backwards. Why not using outputs A,B,C,D... and then write the right firing order like in TunerStudio for megasquirt? The harness was ready and installed on june 13th 2012. Sensors were tested OK. Ignition also OK on the test mode: ignition out 0 drives cyl #1 coil... firing order 054321-->153624 First attempt to start: the ECU asked for Password which I had not. VEMS shop sent it to me then another problem was that ECU was in Safe Mode. Ignition and injection outputs were disabled. Solution: just upload the config file again. First start: unsuccesful. Big pop sound on the exhaust. I checked the sparks and everything was OK. I tried to reduce cranking VE in case the engine was flooded. No succes. June 15 I verified if the ignition sequence was right. Method: unplug the first spark plug and just let it on the spark hole. Put a spare spark plug on the corresponding coil plug. Start the car and check if spark occurs on the compression stroke. Result: The spark did not occur on the compression stroke so I had to shift up the outputs (ignition outputs table) The car started right after shifting the outputs 3 times. Question: Why is the firing order different? now the firing order is 624153 TODO: testing the Vanos and camshaft movement. Question: Camshaft target table: what values put avance and what put retard?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.