##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ######  
         

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

         
         
  ####   
 #    #  
 #    #  
 #    #  
  ####   
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
get error : file "vems.hex" is missing. duplicate from report: http://vems.hu/vemstune/bugreports/reports.php?cmd=view&key=zprqad ----- Hello Rico_pl, Upgrade to firmware higher than 1.2.11 requires bootloader upgrade, please follow the procedures on: http://vems.hu/vt/help/v3/general/bootloader_upgrade.html Best regards, Dave ---- Thanks Dave, as I bought the car with VEMS unit (Escort Cosworth), I have set Trigger to "Lancia_cosworth". My first error report shows I have trigger signals but RPM is 0 while cranking. Acc. to WIKI I should use firmware 1.2.26+. Is this correct ? Or should it work also with 1.2.11 ? I cannot see why RPM stays 0 while cranking. Fuel is injecting. BR, Rico ---- Hello Rico, To assist you in your startup/trigger debug, i would need the following: * a triggerlog of engine cranking 8-10 seconds no IGN or INJ fuses * a vemslog of the same sequence Using these i can get a beter understanding of whats going on. You can upload these files to the FileArea and link here or fire a sharing report (from VT) and link that. We'll work from there. Best regards, Dave ----- Hi Dave, here the link http://vems.hu/vemstune/sharingcenter/reports.php?cmd=view&key=pmPtyJ BR Rico ---- Hello Rico, I have reviewed your triggerlog and vemslog, this trigger type should work with special trigger type = Normal, Tdc after the trigger is likely to be around 60deg, use a timing light to verify and adjust. I have attached a corrected config (having these suggested changes) to your sharing report. Best regards, Dave ----- Thanks I will test this. But why is RPM =0 ? I thought it triggers on TDC so 0 degree ? BR, Rico
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.