##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 #    #  
 #    #  
 #   ##  
  ### #  
      #  
  ####   

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

 _   _ 
( ) ( )
| |_| |
|  _  |
| | | |
(_) (_)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm coming to that stage where I need to solder in the output drivers (WB02, injectors and ingition). I've been looking at: http://www.locustom.com/images/ms_avr/mini_board_setup_fets.jpg I am planing on using: * 1 x WB02, with heater control: use EC18/18 * 4 x injectors, [Semi] Seq, can I use B,C,D,E or do I have to use A,B,C,D ? ** BCDE is fine, but more common to populate all 8 injector FETs: these are very useful, and more rugged than - say p259 outputs. Control inductive loads like relays (eg.fuel pump relay ) with injector output, than the flyback protection is there *** if using p259 output for relay, solder diode anode to the output and diode cathode to the constant +12V of the relay. Not needed when driving a LED. * 1 x wasted spark coil pack, do I have to use 00, 01 or can I use 02 & 03? ** actually 2 & 3 recommended, so that it is compatible with preassembled controller (check WebShop) when ordered with 2 IGBT MembersPage/PhatBob Yes Heater control, 18. Injectors and coils you can use what ever ones you wish - you will just need to configure them in software (h[] tables) and obviously use the appropriate connections on the EC36 plug Personally I'd do them A B C D... but then I fill the board up so that I have room to expand should I want to drive other solenoids at a later date.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.