_____ 
|  ___|
| |__  
|  __| 
| |___ 
\____/ 
       
       

  ____  
 / ___| 
 \___ \ 
  ___) |
 |____/ 
        

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ###### 
         

 ##      
 ##      
 ##  ##  
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm coming to that stage where I need to solder in the output drivers (WB02, injectors and ingition). I've been looking at: http://www.locustom.com/images/ms_avr/mini_board_setup_fets.jpg I am planing on using: 1 x WB02, with heater control - I need to use No. 18? 4 x injectors, [Semi] Seq, can I use B,C,D,E or do I have to use A,B,C,D ? 1 x wasted spark coil pack, do I have to use 00, 01 or can I use 02 & 03? I think thats it for now :-) MembersPage/PhatBob Yes Heater control, 18. Injectors and coils you can use what ever ones you wish - you will just need to configure them in software (h[] tables) and obviously use the appropriate connections on the EC36 plug Personally I'd do them A B C D... but then I fill the board up so that I have room to expand should I want to drive other solanoids at a later date.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.