####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

 _       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

 #       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
First thing to address is the trigger. The signal is taken from the Jacobs + distributor trigger, and here's the 0.76 Volt square-wave signal: http://vems.hu/files/MembersPage/RichardBarrington/RangeRover/rover-trigger-big.jpg '''How to read this safely?''' 0.76V is a bit too low for a HALL setup. It might work, with some experimentation: * '''try a stronger pullup and a voltage divider:''' ** distributor_signal (the above scopeshot) - 270 Ohm - (ECM HALL input connected here) - 1k Ohm - +5V (EC38pin28) If this does not help (try to play with the values, eg. try several values from 680 Ohm to 4k7 instead of the 1k resistor). Shaping the signal with active components (transistor, inverter, amplifier) is probably not justified. '''VR setup''' VR does not require high amplitude, but requires the signal to go under 0V. A series cap is necessary. Min 10uF 25V * eg. the 1210 size cap in the GenBoard/VerThree/RescueKit could work * or a bigger throughole * or several capacitors in parallel. '''Result of VR test''' With no cap installed, and the engine still, the ECU reads many thousands of RPM (it varies) and triggers the injectors. With a 10K electrolytic cap in series it seems to read OK when triggered manually (opening the points rapidly with a screwdriver) BUT before or afterwards when stopped with ignition on, the ECU again reads many thousands of RPM and fires the injectors. Tried it with a 22 uF BP electrolytic cap, and also with 10k to 20k of R in series. The scope shows a signal of .4V peak-to-peak, about 20ms period - this without the engine running. Sometimes it was fine and read 0 RPM with a clean waveform, but when noisy the RPM was all over the place again. * Anyone got ideas, or should I try the Hall approach instead (means soldering the ECU again :( )? ** document the history of the ECM. *** Version 3.2 *** Serial *** What did you install (eg. R181 ?) *** LM1815 pin5 ? (adaptive hysteresis) *** [Photo] *** Firmware 1.0.23 *** config (the simple coil-type trigger is more prone to noise than multitooth, especially with the advanced multitooth filter) *** tables
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.