_______ 
(       )
| () () |
| || || |
| |(_)| |
| |   | |
| )   ( |
|/     \|
         

      #  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

______ 
|  _  \
| | | |
| | | |
| |/ / 
|___/  
       
       

         
         
 ##  ##  
 ##  ##  
 ######  
 ######  
 ##  ##  
         

  _____  
 |  __ \ 
 | |  | |
 | |  | |
 | |__| |
 |_____/ 
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''!MonitorEngine''' This !UseCase describes the Driver monitoring the engine state while driving. ---- The !UseCase starts when the Driver connects the computer, starts the software, and enables the ignition. The software displays engine runtim information in realtime, in a familiar and visually appealing manner. This will be as gauges or illuminated icons as most appropriate, and as most often used on existing car dashboards. The following information is displayed: * Engine speed in revolutions per minute * Coolant temperature in celsius * Battery voltage in volts * Ignition advance in degrees * Lambda in lambda units * Exhaust gas temperature in celsius * Manifold air pressure in bar * Manifold air temperature in celsius * Throttle position in percent * Injector duty cycle in milliseconds (or percent?) * Total enrichment in percent * Knock as a lamp * Wideband lambda activation as a lamp * Nitrous solendoid activation as a lamp * Coolant fan activation as a lamp * Water pump activation as a lamp * RPM limiting as a lamp * Oil temperature * Oil pressure * Transmission temperature ''Anything else wanted or needed?'' Maybe you can create individual displays for each enrichment variables,so users would have more information about what they doing.I personally need it,but it would be also great if it would be switchable.NanassyPeter The software presents the default selection of gauges by reading configuration data from a gauges.xml file, in a custom XML format. The Driver may display the gauges in full screen mode if desired, by selecting Display->Fullscreen. In the event of out-of-range or dangerous readings (high EGT or low oil pressure for exammple), an audible alert is generated. If the affected display is a gauge, it will display an error lamp on the face. After the run, when RPM has dropped to zero, or idles for several minutes, the software suggests making a diagnostic and runtime log for analysis. The display is updated continuously until the Driver ends the session or chooses another function within the software. ---- Back to MembersPage/RichardBarrington/QTune/UseCases
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.