_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
___) (___
\_______/
         

    ##   
         
   ###   
    ##   
    ##   
    ##   
 ## ##   
  ###    

   ##    
         
  ###    
   ##    
   ##    
   ##    
  ####   
         

   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

  _____ 
 |_   _|
   | |  
   | |  
  _| |_ 
 |_____|
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
''Warning: Impressions are written from a new user / first timer perspective. Bulleted recommendations are from my own perspective.'' ---- Received the package. The 3.2 board looks good quality. * Needs to be thoroughly cleaned. Took a few goes with Electrolube Fluxclene and a nail-brush to get the residue off. Wasn't too impressed with case endplates - different materials and the rear plate wasn't machined to take the seals. Screws were ambiguous... * Paint endplates black to match case, and ensure machining is done (QA). * Change screws for some stainless allen head cap-screws. 8 packaged together. * Black seals too please. Spent some time in wiki looking for where to start building/testing. Couldn't quite find where to begin the required assembly (if any). Searched for specifics on functions I knew I'd need - serial, idle stepper, WBO2, injector drivers. * Clear link from board description page to a step-by-step assembly guide. Big arrow / start here / etc. * More pictures needed in wiki. Any fuses or components that may need to be added should have a photo as well as a description. Eg, the stepper chip. Soldered on a 3-pin header for serial communications. Didn't see an obvious description of how to connect serial via the EC. Soldered on the stepper driver. Soldered on the MAP sensor, without screws holding it to the board. No mention of orientation, and both the body and the nozzle foul components on the board depending on which side is used. ---- Back to MembersPage/RichardBarrington Back to MembersPage/RichardBarrington/TonysCapri
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.