___   
(  _`\ 
| (_) )
|  _ <'
| (_) )
(____/'
       
       

    #    
 ######  
   ##    
   ##    
   ##    
   ## #  
    ##   
         

      #  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi :) Need som help setting up my VEMS Motronic-55. ---- Engine info: It`s an ADU engine, 5 high output coils with built in drivers. 720cc injectors at the moment, have some 1600cc (4.5ohm - need resistor?) custom cams and ported cylhead JE pistons H-beam rods 82.5mm bore 92.6mm stroke Turbonetics gtk 650 89mm exhaust 034 motorsport high output coil pack (5 coils) standar POS not used. --- Q: I have changed my mind, and want to go for the NTC type IAT sensor. My vems is set up for the PTC type. What to do? A: ? ---- Q: I have some msq files for the motronic 55, but i can not understand the ignition outputs.. what is H[2]? and what does 04..00 stand for? Does this have any thing to do with the fiering order? A: The H2 is the exact firing order of the ign outputs more info at this page http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FDigitalOut%2FTable If the car is Audi s2 you will find some useful info in this page http://www.vems.hu/wiki/index.php?page=MembersPage%2FPeterJensen/AudiSwiring Regards Peter ---- Q: What firmware to use? can i use 1.1.23 12x12? A: Don't use 1.1.23. See this page: MembersPage/MattiasSandgren/OskarAudiSFour \\ Download 1.1.27 on the MegaTune page and go from there. \\ Q: How to upload tempsensor files? A: You have to use the tempsensor_upload script that comes with the MegaTune package to upload a firmware containing the correct temperature tables, see EasyTherm and EasyTherm/SensorTable. ---- Q: When i downloaded megasquirt, there was a PINOUT picture included.. Is there a simular picture for the Motronic 55 plug? A: Begin reading here: VemsAudiAan Reidar Reply: Can not see that this is right for the aan, aby and adu engine? and it`s quite hard to read from it.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.