_____ / ____| | (___ \___ \ ____) | |_____/
# # # # # # # ## ### #
### ## ### ## # ##### ## ## ## ## #### ###
_________ \__ __/ ) ( | | | | | | ___) (___ \_______/
### ## ### ## ## ## ## ## ### ## ## ## ###
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD Start] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FQuestions Questions ] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FInjector Injector] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FIgnition Ignition] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FTrigger Trigger] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FDisplay Display] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FWbo Wbo] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FConfig Config] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FTables Tables ] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FIdle Idle] || Trigger data (firmware 1.0.69) ---- Primary triggering: Currently using the stock Peugeot (Magneti Marelli) triggering. It uses a 60-2 flywheel with VR sensor. The first tooth after the missing tooth is at 120 degrees before TDC of cylinder 1. Config: primary_trigger=01 # multitooth, rising edge secondary_trigger=02 # disabled/not available tooth_wheel=3A # 60-2 = 58 teeth trigger_tooth=02 # first tooth after missing tooth another_trigger_tooth=1E # trigger 180 degrees later = 30 teeth later crank_minper=EA # Others have 50 tooth_wheel_twidth1=02 tooth_wheel_twidth2=06 ---- Secondary trigger: Currently the engine does not have a secondary trigger. I will therefor run batch injection and wasted spark. After I know the ins and outs of this setup i will use a secondary trigger for sequential injection and coil on plug for better control. I think a VR sensor is easiest to apply. More about that later. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.