####  
  ## #   
  ##     
 #####   
  ##     
  ##     
 ####    
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

         
|\     /|
( \   / )
 \ (_) / 
  ) _ (  
 / ( ) \ 
( /   \ )
|/     \|
         

 _____ 
|_   _|
  | |  
  | |  
  | |  
  \_/  
       
       

  _____
 |__  /
   / / 
  / /_ 
 /____|
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD Start] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FQuestions Questions ] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FInjector Injector] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FIgnition Ignition] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FTrigger Trigger] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FDisplay Display] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FWbo Wbo] ||[http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FConfig Config] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FTables Tables ] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FRallyeNLD%2FIdle Idle] || ---- '''Problem with calibration of the WBO2 sensor:'''firmware 1.1.12 * LCD shows maximum O2% of 16.0% (wbo2_calibration = 0xFF) * should be near 20.9% but is 16.0% * Sensor is a LSU4 sensor from the webshop Other calibration steps were perfect: * Pump zero DC voltage = 0V (measured between pin 5 and 6) * Pump PID nernst target; between pin 5 and ground = 4V * Pump PID nernst target; between pin 5 and pin 1 = 0.45V '''Relevant config''' wbo2_warmup_ramp=A0 wbo2_abs_limit=00 wbo2_limit_maxt=A0 wbo2_fallback=60 wbo2_retry_t=06 wbo2_ri_target=96 wbo2_nernstdc_target=89 wbo2_pump_pw_zero=64 wbo2_calibration=FF wbo2_heater_pid_kp=45 wbo2_heater_pid_ki=11 wbo2_heater_pid_kd=1A wbo2_heater_pid_ilimit=81 wbo2_pump_pid_kp=15 wbo2_pump_pid_ki=4E wbo2_pump_pid_kd=00 wbo2_pump_pid_ilimit=FF wbo2_ri_confidence_scale=80
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.