___   
(  _`\ 
| (_(_)
|  _)_ 
| (_( )
(____/'
       
       

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ###  ## 
         

   ___  
  / _ \ 
 | | | |
 | |_| |
  \___/ 
        

 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 #####   
         

 _____ 
(  _  )
| ( ) |
| | | |
| (_) |
(_____)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Introduction''' In the progress of installing Genboard 3.3 on a Yamaha R6 engine, a 600cc motorcycle engine from the year 2000. Had som initial problems, but now the engine has fired up! Just have to adjust it to run properly. '''Data on the setup/install''' The engine is an 600cc, inline 4-cyl, fourstroke motorcycle engine. Revlimit ~15500rpm, firingorder 1342. I'm using the stock passive COP, connected in series (=> wastefire). Injectors are high impedance Bosch-units of standard design. The CPS is working together with a 8-1 wheel (modified stock wheel from a '05 Yamaha Fazor motorcycle, perfect fit on this engine). No cam sensor. [http://www.tfd.chalmers.se/~burenius/vems/cellen.jpg Current picture of the engine, in its cell] The GenBoard is a preassembled v3.3-board with the following options: 4+4 ignition drivers Knock + 2 EGT 250kPa onboard MAP PowerFlyBack VR Primary Trigger Hall Secondary trigger [http://www.tfd.chalmers.se/~burenius/vems/vems-schematics.gif Schematics]. --- The VEMS-setup currently work fine and engine tuning is progessing.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.