_      
 | |     
 | |     
 | |     
 | |____ 
 |______|
         
         

 _____ 
|  __ \
| |  \/
| | __ 
| |_\ \
 \____/
       
       

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Emergency with MembersPage/RagnarBurenius now: 2006-06-14 Wed (actually still June 13th on West Coast, 23:32) We have an '''emergency situation on USA West Coast,''' The team '''needs a VEMS v3.x ECU by Thursday''' (preferrably '''2006-06-15 Thursday morning USA West Coast time''', so they can install: they have the config and tables, just need to plug in, and upload) ---- '''Communications''' to handle the situation: * write here, on this page * I made a #v3needed for this emergency situation irc channel on the same (efnet) where our #avrboard channel is hosted: see ChatViaIrc * from the onsite team contact: phone: +46709557097 Ragnar Bolemius (Swedish guy, in the USA now, this is his cellphone) ---- '''Destination address:''' * www.acpropulsion.com * http://www.acpropulsion.com/ACP_contact_information.htm * AC propulsion * Henry Chea * 441 Borrego Court * San Dimas * CA 91773 * USA ---- '''Setup:''' * 250kPa MAP sensor is fine * non-demanding 4 cyl wasted spark app, * primary trigger VR * secondary trigger: don't care '''Even unassembled genboardv3.x would work as last chance''' * + with Econoseal connectors (EC18PCB + EC36PCB) * + FETs (min 6, preferrably 10) * + IGBTs (min 2, preferrably some spare too) * + 250 kPa MAP sensor * + powerflyback - * the rest ** + Alubos - would be nice ** + 3 clamping plates and 3*10 mm screws would be nice ** + frontplate optional ** - endplate truly optional ** - stepper chip not needed It's pretty impossible to send there from outside USA in this incredibly short timeframe (Fedex, UPS, TNT etc... only that fast when very lucky, and sent just at the lucky time when their plane takes off) When USA wakes up, I'll try to reach the guys via phone who might be able to send one there in the timeframe, but any help or idea is appreciated. WebShop will cover shipping costs too, and provide another ECM (possibly with different setup if needed) or price of it, and Ragnar will be very grateful too. thanx, Marcell tel:+361 2809637 (or +36702654789)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.