_______ 
(  ____ \
| (    \/
| |      
| |      
| |      
| (____/\
(_______/
         

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ######  
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

  _   _ 
 | \ | |
 |  \| |
 | |\  |
 |_| \_|
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
car is Audi S4 Avant with AAN engine. Car doesn't start. it gives something like 5 misfires for 6-10 sec starting. When i tryed without HALL inverter the engine gave some backfires but still not started. If the HALL signal and Flywheel triger wasn't aligned correctly the engine sometimes started. The setup uses HALL trigger from distributor. The HALL signal is inverted. Config: primep=DC primep_temp_scaling=33 cwl=8C cwh=23 cranking_thres=03 awev=AA awev_temp_scaling=26 awec=22 warmup_clt_range[0]=00 warmup_clt_range[1]=00 warmup_clt_range[2]=04 warmup_clt_range[3]=18 warmup_clt_range[4]=50 warmup_clt_range[5]=64 warmup_clt_range[6]=78 warmup_clt_range[7]=8B warmup_clt_range[8]=A6 warmup_clt_range[9]=D4 warmup_clt[0]=96 warmup_clt[1]=91 warmup_clt[2]=8C warmup_clt[3]=46 warmup_clt[4]=3C warmup_clt[5]=32 warmup_clt[6]=23 warmup_clt[7]=14 warmup_clt[8]=0F warmup_clt[9]=05 warmup_rpm_scale=4D req_fuel=27 divider=01 alternate=04 injopen=00 battfac=22 kpafac=D0 kpaoffs=8B injocfuel=01 injrampup_battfac=FF injpwm=FF injpwmt=FF als_launch_input=CF rpmk[0]=09 rpmk[1]=60 tpsdot_kpadot_conf=00 tpsdotrate[0]=02 tpsdotrate[1]=0A tpsdotrate[2]=13 tpsdotrate[3]=1D tpsaq[0]=01 tpsaq[1]=02 tpsaq[2]=03 tpsaq[3]=04 als_cut_mintps=FF tpsasync=0A acmult=AA tpsacold=0A launch_enrich=00 launch_retard=00 overrun_fuelcut=1C overrun_fuelresume=1B rev_limit=43 airden_ignore=64 config11=41 config12=40 config13=02 batt_cal=C0 fastidle=C6 als_max_cut=00 dbaro=0A tps_low=18 tps_high=E6 fan_temp=EA fan_hyst=05 fan_channel=FF iac_step_seq=D8 iac_conf=5A iac_max_steps=1E iac_tps_thres=03 iac_cold_idle_temp=7E iac_warm_idle_temp=B4 iac_cold_rpm=78 iac_warm_rpm=50 iac_cold_start_pos=FF iac_warm_start_pos=80 iac_afterstart_rpm=1E iac_afterstart_duration=32 iac_speed=01 iac_kp=2A iac_ki=16 iac_kd=0A launch_rpm=FF iac_integral_limit_dec=0A iac_integral_limit_inc=14 iac_integral_deadband=0A iac_deadband=0A als_cut_maxtps=FF iac_overclose_interval=C8 iac_ref_pos[0]=BF iac_ref_pos[1]=BA iac_ref_pos[2]=8C iac_ref_pos[3]=70 iac_ref_pos[4]=6E iac_ref_pos[5]=6B iac_ref_pos[6]=69 iac_ref_pos[7]=66 iac_ref_pos[8]=61 iac_ref_pos[9]=57 iac_sol_channel=60 iac_ign_slope=18 softrpm_range=32 iac_ign_advance_limit=30 iac_ign_retard_limit=18 iac_ign_threshold=0C ego_conf=06 ego_lag=04 ego_coolant=7E ego_maxtps=E6 ego_maxmap=78 ego_minrpm=14 ego_maxrpm=46 ego_warmup=14 ego_lean_limit=03 ego_rich_limit=03 ego_pid_kp=1E als_enrich=00 ego_delta=03 ego_target=19 ego_pid_window=01 wbo2_warmup_ramp=FF als_react_tps=FF wbo2_abs_limit=E0 wbo2_limit_maxt=F0 wbo2_fallback=70 wbo2_retry_t=06 als_retard_rpm1=FF als_retard_rpm2=FF wbo2_ri_target=A5 wbo2_nernstdc_target=86 wbo2_pump_pw_zero=67 wbo2_calibration=C3 wbo2_heater_pid_kp=45 wbo2_heater_pid_ki=11 wbo2_heater_pid_kd=1A wbo2_heater_pid_ilimit=80 wbo2_pump_pid_kp=15 wbo2_pump_pid_ki=4E wbo2_pump_pid_kd=00 wbo2_pump_pid_ilimit=FF wbo2_ri_confidence_scale=80 knock_chan=01 knock_sampling_window=F2 knock1_frequency=29 knock1_gain=00 knock1_integrator=0F knock2_frequency=29 knock2_gain=00 knock2_integrator=0F knock_threshold=0A knock_noise_scale=AA knock_max_retard=50 knock_default_retard=08 knock_retard_step=04 knock_retard_delay=30 knock_advance_step=01 knock_advance_delay=50 knock_minrpm=0A knock_maxrpm=4C ve_learn_coolant=CF ve_learn_max_power=64 ve_learn_rpm_scale=28 ve_learn_kpa_scale=28 ve_learn_ego_scale=50 ve_learn_min_weight=14 ve_learn_speed=32 ve_learn_limit=80 ve_learn_conf=00 lcd_c0=FE lcd_delay=42 lcd_backlight=FF kpa_conf=22 als_igncut_rpm2=FF als_retard_mintps=FF als_retard_maxtps=FF lcd_default_view=02 primary_trigger=43 secondary_trigger=19 tooth_wheel=5A trigger_tooth=08 another_trigger_tooth=12 crank_minper=33 tooth_wheel_twidth1=20 tooth_wheel_twidth2=00 cam_sync_r_edge_phase=00 cam_sync_f_edge_phase=00 reset_engphase_after=40 ign_tdcdelay=84 ign_dwell14=C3 ign_dwell6=38 ign_crank_advance=30 ign_out=70 ignchmax=04 engine_off_delay=04 pump_on_mintime=06 fuelpump_channel=70 inj_stage2_rate=FF inj_stage2_start_tps=FF inj_stage2_start_map=FF als_igncut_rpm1=FF als_deact_time=00 als_deact_egt=00 als_retard=CC als_rev_limit=FF misc1out_minrpm=00 misc1out_maxrpm=0C misc1out_mintps=4D misc1out_maxtps=FF misc1out_minmap=00 misc1out_maxmap=64 misc1out_channel=7F misc2out_minrpm=FF misc2out_maxrpm=FF misc2out_mintps=FF misc2out_maxtps=FF misc2out_minmap=FF misc2out_maxmap=FF misc2out_channel=FF act_wot_rpm=FF act_wot_channel=FF act_rpm_rpm=FF act_rpm_channel=FF egt1_cal=4B als_tks_channel=FF boost_conf=61 boost_targetoffs=00 boost_minpressure=36 boost_pid_kp=FE boost_pid_ki=64 boost_pid_kd=1F boost_pid_ilimit=6E boost_channel=50 water_pump_temp=00 hybrid_rpm_a=00 hybrid_rpm_m=00 water_pump_hyst=7E water_pump_channel=FF toothrel_normal=76 toothrel_missing=00 fuelcut_min_kpa=08 fuelcut_max_kpa=8C tach_channel=17 tach_div=11 shiftcut_conf=00 shiftcut_channel=FF shiftcut_time=7F softrpm_rpm=3E
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.