#       
 #       
 # ###   
 ##   #  
 #    #  
 ##   #  
 # ###   
         

  ___ 
 |_ _|
  | | 
  | | 
 |___|
      

 _   _ 
( ) ( )
| | | |
| | | |
| \_/ |
`\___/'
       
       

     _    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

  ____  
 |  _ \ 
 | | | |
 | |_| |
 |____/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Damo has an issue with his v3.3 (serial number 612) When he checked the O2 reading to check that the calibration constant that I had given him from my test bench calibration of his sensor was correct, he found that the calibration value of D7 gave a O2% reading of 14.4 E7 gave a calibration value of 15.x and FF gives 16.x He is using the suggested wbo2 settings, and has the correct wbo2_nernstdc_target and wbo2_pump_pw_zero values as defined from the Webshop delivery sheet. The wiring appears to be correct and the battery voltage is good. Does anyone have any suggestions for further tests or possible causes? ----- {{ wbo2_warmup_ramp=A0 }} {{ wbo2_abs_limit=E4 }} {{ wbo2_limit_maxt=A0 }} {{ wbo2_fallback=B0 }} {{ wbo2_retry_t=06 }} {{ wbo2_ri_target=96 }} {{ wbo2_nernstdc_target=85 }} {{ wbo2_pump_pw_zero=67 }} {{ wbo2_calibration=FF }} {{ wbo2_heater_pid_kp=46 }} {{ wbo2_heater_pid_ki=10 }} {{ wbo2_heater_pid_kd=1A }} {{ wbo2_heater_pid_ilimit=80 }} {{ wbo2_pump_pid_kp=15 }} {{ wbo2_pump_pid_ki=4E }} {{ wbo2_pump_pid_kd=00 }} {{ wbo2_pump_pid_ilimit=84 }} {{ wbo2_ri_confidence_scale=80 }}
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.