##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 #####   
         

      #  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

  _____  
 |  __ \ 
 | |__) |
 |  ___/ 
 | |     
 |_|     
         
         

   ____ 
  / ___|
 | |  _ 
 | |_| |
  \____|
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
*Need help for setting up 36-1 trigger Edge = rising Type = multitooth Filtering = Disabled TDC after the trigger (vr sensor) deg =?? Number of teeth on the wheel = 35 36-1 Trigger tooth = 1 Number one tooth after the missing one Next Trigger tooth = 18 Crank min period usec = 3000 (assuming a 4cyl that is 6000usec for a whole crank rotation, which is 10000 RPM) ---- * reset_engphase_after=decimal 216 (which is an arbitrary number for 720 crankdegrees, practical for 36 tooth wheel). The values below are in the same unit: * Angular width of tooth = 3 (10 degrees) 360/36=10 * Angular width of missing tooth = 6 (20 degrees) http://www.vems.hu/files/PeterJensen/trigger_setup.jpg http://www.vems.hu/files/PeterJensen/trigger/36-1_2vems.jpg http://www.vems.hu/files/PeterJensen/trigger/36-1.jpg http://www.vems.hu/files/PeterJensen/trigger/36-1_1.jpg http://www.vems.hu/files/PeterJensen/trigger/36-1_2.jpg PeterJensen/trigger/beslag_1.jpg PeterJensen/trigger/beslag_2.jpg How do you mount the HALL sensor? It's a HALL sensor in a shatter-arrangement, right?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.