####   
 ##  ##  
 ######  
 ##      
  ####   
         

         
  ####   
     ##  
  #####  
 ##  ##  
 ##  ##  
  ### ## 
         

 ___   
(  _`\ 
| (_) )
|  _ <'
| (_) )
(____/'
       
       

      #  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

 _   _ 
( ) ( )
| `\| |
| , ` |
| |`\ |
(_) (_)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Mitsubishi 6g72 6 cyl. Also see MembersPage/GergelyLezsak/MitsuSixGSeventyTwo ---- '''Supported in VEMS''' * money-back guarantee if one has a project page with this trigger but still fail to run it after reasonable cooperation (capturing triggerlog, providing vemslog and measurement info might be necessary as usual) ** use EVO configlet, but set 6 cyl and '''falling / falling''' (primtrig/sectrig edge). Config will be refined (fw mod will be implemented if really needed, but apparently not needed) ** '''Play trigger: l006''' in vemstune is good for benchtesting (or [http://vems.hu/files/sensors/Trigger/Mitsubishi/Mitsubishi_6G72/ l006_202-5000_10_50_1000_1000.wav] generated by command./signalgen l006 202-5000 10 50 1000 1000 ) ** although '''camsync with l006 is Lancia/Cosworth pattern''' with only 2 pulses (luckily NOT N*120 deg apart !) it is possible to test that syncing to <53 deg works *** interestingly, l006_202-5000_10_50_1000_1000.wav signal can be used for same benchtesting purpose, even with a VR-VR ECU, if soundcard has (both) channels inverted (usually NOT the case for VR inputs and real teeth, but often - intentionally - happens with generated signals). When benchtesting with HALL ECU the input edge can be chosen arbitrarily, so no such issue Q: do we support this trigger http://www.msextra.com/doc/ms2extra/MS2-Extra_Mits6g72.htm Yes ---- Q: will invert logic level work on this ign endstage http://www.seekic.com/circuit_diagram/Automotive_Circuit/ChangFeng_LieBao_SUV_6G72_engine_ignition_system_circuit.html A: I cannot see the reason for the center box, that can enable or disable ignition, I would personally bypass this and hook normal IGBT outputs straight to the actual coil. *It could be nice if we could get the oem endstage to work, it will save a lot of time and good support for anyone else. //Emil /Peter http://www.vems.hu/files/MembersPage/PeterJensen/mitsu/trigger.JPG http://www.vems.hu/files/MembersPage/PeterJensen/mitsu/6g72.gif http://www.vems.hu/files/MembersPage/PeterJensen/mitsu/ign.gif
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.