##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

         
         
 ######  
 #  ##   
   ##    
  ##  #  
 ######  
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Firmware requisition''' 1: Anytime control **Is it possible to make a timer off delay? Why...if using a electronic charger (clutch) we must prevent it to not go off while change gear but the output must stay high as long the timer is not run out. ---- 2: Anytime control **Is it possible to make anytime control use a input + normal parameters ? Why... using A/C Subaru we have a signal (12v) from a/c that order a/c to start-stop and the ecu must set the conductions if rpm is above 4000 the output go low. If not using the input the a/c pump will be active all the time in normal conductions and then burn ---- 3: Config switching **Can we make config 1-2 regards of Tps Why... If you start the car normal way it will stay on config 1 but if Tps is >95% then config 2. vehicle inspection State dependent ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.