#####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

 ___   
(  _`\ 
| |_) )
| ,__/'
| |    
(_)    
       
       

         
|\     /|
| )   ( |
| | _ | |
| |( )| |
| || || |
| () () |
(_______)
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Firmware requisition''' '''17/3-2016''' We need 2nd serial port to stream AIM data As almost no one using this port (GPS) it will be great to connect round only and android at the same time. Serial port1 triggerframe '''Serial port2 AIM datastream''' This is technically possible and we'll strongly consider this. ---- '''Old stuff below do not comment''' 1: Anytrim control **Is it possible to make a timer off delay? Why...if using a electronic charger (clutch) we must prevent it to not go off while change gear but the output must stay high as long the timer is not run out. An analog input to a digital output ? Can you make a more detailed description (with practical min and max time values) ? * input falling at 0 msec ** output ... ** output ... * input rising at (say) 300 msec ** output ... ** output ... What is desired if input rises (deactivates) before the falling=> sequence has ended ? ---- 2: Anytrim control **Is it possible to make anytime control use a input + normal parameters ? Why... using A/C Subaru we have a signal (12v) from a/c that order a/c to start-stop and the ecu must set the conductions if rpm is above 4000 the output go low. If not using the input the a/c pump will be active all the time in normal conductions and then burn ---- 3: Config switching * Can we make config 1-2 regards of TPS Why... If you start the car normal way it will stay on config 1 but if TPS is >95% then config 2. vehicle inspection State dependent * TPS >= 70% (or so) is flood clear mode (as in most factory cars). Injection disabled during cranking (engine will NOT start). * config switching is possible with: ** I-button ** or '''with analog input (switch, hidden or not). Most often applied''' ** or with misc-condition (often used for NOS, rarely used at engine startup) ** or with VT ** or with relevant serial commands issued some other way Currently we think this is a practical number of methods for config-switching. ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.