##  ##  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

__   __
\ \ / /
 \ V / 
 /   \ 
/ /^\ \
\/   \/
       
       

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Consumer: Stage3.dk Car: Vw polo make separate page for your project. (no confusing data about other cars) please split it NOW important details about the setup this is mostly provided now (after repeated requests) full .vemscfg config (not .msq) We are trying to set-up coil type trigger, 4+1 but without camsync (using distributer). Car Vw polo turbo Basic info 4 cyl Firing sequence 1342 ign wiring : using one coil ec 36 pin 10 Trigger is original disturber type hall. Two signals pr. Crank Rev. Firmware 1.1.62, but 1.1.70 recommended - benchtest if possible. Review all tables (disable anytrim if not used). Primary trigger Settings: Edge: rising Type: coil typ Missing tooth: typ --- Special trigger type: Normal Tdc after the trigger: 10 Number of teeth on the wheel: 4 ( 2 is BAD) First trigger tooth: 0 Next trigger tooth: 1 Angular width of the teeth: 180 (90 does not make sense) Crank min: 2000 lower, even 0 would be OK Filtering: Enabled Advance filtering: Disabled Secondary trigger: disabled Trigger ref tooth: 0 3 2 1 rest 4 does not matter ... Coil charge time map scale: 0 (Dwell is flying around) or 1 can be OK tested successfull on branch with the following config: http://www.vems.hu/files/PeterJensen/v3.3_n001212-2010.03.22-11.43.24.vemscfg (check the outputs, this is different from your)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.