|\     /|
| )   ( |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

         
         
 #    #  
 #    #  
 #    #  
 #   ##  
  ### #  
         

___  ___
|  \/  |
| .  . |
| |\/| |
| |  | |
\_|  |_/
        
        

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

 _______ 
(  ____ )
| (    )|
| (____)|
|  _____)
| (      
| )      
|/       
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
---- Added a 20K resistor (12..15k is better, sometimes 20k is too high) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_1.jpg Soldered JP7 http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_2.jpg Mounting the stepper chip http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_3.jpg C103 replace with 1nF (only needed on certain boards from a given old batch, 2005 or so) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_4.jpg added 1uF cap in parallel with C40 http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_5.jpg R182 shorted http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_6.jpg Made wire for the crankhome-VR trigger input (EC18 pin 12) http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_7.jpg Connected JP 2 and JP 7 so the primary trigger goes where it needs to: http://www.vems.hu/files/MembersPage/PeterJensen/audi_trigger/trigger_8.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.