#####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

         
|\     /|
( \   / )
 \ (_) / 
  \   /  
   ) (   
   | |   
   \_/   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Subpage of MembersPage/PeteLeh''' '''132+1 Porsche 944 turbo trigger''', no missing teeth anywhere, a variation of InputTrigger/AudiTrigger '''without cam-HALL inverter''': * primtrig: VR sensor ; 132teeth on flywheel ** note: no pullup resistor inside ECU ** not sure if this was intentional, but should NOT matter normally ** if signal has severe noise eg. from WBO2 heater or other source, harness can be fixed, or primtrig 18k pullup to 5V might help suppress the noise. * sectrig: VR sensor ; Crank home (1 pin on flywheel 24.5 tooth, ie 66.8 dec BTDC 24.5 x 2.7272 deg, if i remember right) No cam sensor ---- Ignition sequence: 1-3-4-2 ---- '''Configuration error: secondary trigger = "Use as primary"''' is invalid for this engine (it is valid if primtrig sensor is connected to sectrig input AND no sectrig is used). * Make sure to configure properly. If uncertain, upload config (or vemslog if it shows something interesting), so we can help review and make recommendations. ---- See VemsTuneVersion
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.