##    
         
  ###    
   ##    
   ##    
  ####   
         

         
         
 ##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

         
         
  ####   
 #    #  
 #       
 #    #  
  ####   
         

 ______  
(  ___ \ 
| (   ) )
| (__/ / 
|  __ (  
| (  \ \ 
| )___) )
|/ \___/ 
         

 ___   
(  _`\ 
| (_(_)
`\__ \ 
( )_) |
`\____)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Introduction ______________________ Hi all! My name is Peep Päädam and i'm from Estonia. I have a modified Porsche 931 w/ 2.0 engine using K26/29 turbo. I'm planning to use VEMS Genboard v3.3 on it. ---- '''[http://techedge.com.au/vehicle/wbo2/wbntk.htm NTK L1H1] WBo2 sensor''' is not supported. note: We now have Bosch LSU4 already purchased for it and LCD too (working), so this section is obsolete * NTK L1H1 sensor (maybe ohm measurements between pair-of-pins?) * there is an NTK sensor under investigation on WideBand (but it's different from the L1H1) http://www.hot.ee/raceboy911/wbuego.jpg and the text on the * sensor: "NTK L1H1" and on the hex-area there's 4-digit number: 0706. * connector: no text on the connector, just 5 wires ---- We are installing my V3.3 to my friends 944 Turbo 3.0 (yes, 3.0) and we're planning to use cam mounted Hall trigger wheel. It's already used on 944T with Tatech EMS and has mounting for two Hall sensors (Honeywell 1GT101DC, datasheet here: http://catalog.sensing.honeywell.com/printfriendly.asp?FAM=solidstate&PN=1GT101DC) and aluminium trigger wheel that has two trigger points per sensor (180 degrees apart, because of the cam mount). Will it work with VEMS without redesigning the trigger wheel/points? The wiring is already done and we're going wasted spark with Bosch coil-pack (everything already waiting for install). Fuel injectors are Siemens 780cc High-Z. Is it possible that someone would help me with setting the constants in MegaTune? Starting values would be: * injopen = 0 * injocfuel = 1200 usec High-Z, so no PWM-ing: * 100% injector duty for 25.5 msec * injector duty = 100% after that
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.