##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

 ###     
  ##     
  ##  ## 
  ## ##  
  ####   
  ## ##  
  ##  ## 
         

    ##   
         
   ###   
    ##   
    ##   
    ##   
 ## ##   
  ###    

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
 #    #  
  #  #   
   ##    
  #  #   
 #    #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi all! My name is Peep Päädam and i'm from Estonia. I have a modified Porsche 931 w/ 2.0 engine using K26/29 turbo. I'm planning to use VEMS Genboard v3.3 on it. I have a question though. I have NTK L1H1 WBo2 sensor, can I use it with GenBoard v3.3? I know it's configured for Bosch LSU4, but maybe firmware update could help? * NTK L1H1 sensor (do you have a picture of sensor and connector? maybe ohm measurements between pair-of-pins?) is unlikely to be supported * there is an NTK sensor under investigation on WideBand (but AFAIK it's NOT the L1H1) Here it is: http://www.hot.ee/raceboy911/wbuego.jpg and the text on the * sensor ... * connector ... On sensor theres just "NTK L1H1" and on the hex-area there's 4-digit number: 0706. There's no text on the connector, just 5 wires. Here's some info on that sensor: http://techedge.com.au/vehicle/wbo2/wbntk.htm
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.