_    _ 
 | |  | |
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

   ____ 
  / ___|
 | |  _ 
 | |_| |
  \____|
        

   ##    
   ##    
  #####  
   ##    
   ##    
   ## ## 
    ###  
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi all! My name is Peep Päädam and i'm from Estonia. I have a modified Porsche 931 w/ 2.0 engine using K26/29 turbo. I'm planning to use VEMS Genboard v3.3 on it. I have a question though. I have NTK L1H1 WBo2 sensor, can I use it with GenBoard v3.3? I know it's configured for Bosch LSU4, but maybe firmware update could help? * NTK L1H1 sensor (do you have a picture of sensor and connector? maybe ohm measurements between pair-of-pins?) is unlikely to be supported * there is an NTK sensor under investigation on WideBand (but AFAIK it's NOT the L1H1) Here it is: http://www.hot.ee/raceboy911/wbuego.jpg and the text on the * sensor ... * connector ...
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.