#####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

 __     __
 \ \   / /
  \ \_/ / 
   \   /  
    | |   
    |_|   
          
          

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi all! My name is Peep Päädam and i'm from Estonia. I have a modified Porsche 931 w/ 2.0 engine using K26/29 turbo. I'm planning to use VEMS Genboard v3.3 on it. I have a question though. I have NTK L1H1 WBo2 sensor, can I use it with GenBoard v3.3? I know it's configured for Bosch LSU4, but maybe firmware update could help? * NTK L1H1 sensor (do you have a picture of sensor and connector? maybe ohm measurements between pair-of-pins?) is unlikely to be supported * there is an NTK sensor under investigation on WideBand (but AFAIK it's NOT the L1H1)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.