_    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

______ 
| ___ \
| |_/ /
|  __/ 
| |    
\_|    
       
       

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

 #       
 #       
 #   #   
 #  #    
 # #     
 ## #    
 #   #   
         

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \___\_\
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Car is Porsche 944 Turbo, 2.5litre inline-4 with K26 Turbo. It has 132+1 auditrigger ('''without cam sync'''). Ordered twin-shield harness for 6cyl from webshop (to have boost controller outputs etc) and VEMS with full auditrigger (2x VR+ 1x HALL) and would like to add cam sync to the engine. Now the question is, '''where should the cam sync event take place with such a configuration?''' * "without cam sync" is mentioned above * the HALL window (EC36/13) should be around one of the crankhome-VR pulses ** make sure the crankhome-VR polarity is good ** if not using camHALL inverter, than EC36/13 should be high around one of the crankhome-VR pulses (or always high if not using camsync) ** if using camHALL inverter, than EC36/13 should be LOW around one of the crankhome-VR pulses (or always low if not using camsync => connect to GND) If no sectrig seen in the triggerlog, than * make sure sectrig is enabled for camsync mode (if not: enable, burn, reboot) * disconnect camHALL sensor and capture triggerlog * pull EC36/13 to GND and capture triggerlog again This will show if camHALL inverter is present or not. If no sectrig either way, doublecheck the crankhome-VR signal.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.