##### ## ## ## ## ##### ## ##
___ |_ _| | | | | |___|
|\ /| | ) ( | | (___) | | ___ | | ( ) | | ) ( | |/ \|
__ __ | \/ | | \ / | | |\/| | | | | | |_| |_|
# # # # ## # # # #
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Car is from year 1997. It sports turbocharged 1.8liter inline four, has passive coil-on-plug ignition system and crank triggers: primary VR (60-2 wheel) and HALL as cam sync. Also it is equipped with strange throttle body. Perhaps it's one unit TPS and idle valve? I took some measurements also: two pins have 45v supply, one pin has 12v supply and one pin had something like 10.x volts supply (measured when engine was not running, only ign. was switched on. That's what it looks like. http://www.hot.ee/raceboy911/A4TB.jpg Looks like a newer version of InTake/ThrottlePlates/VAGElectronicThrottle ------ I connected all the sensors to VEMS unit and everything worked fine (including TPS) but the stock VR sensor. I put the 60-2 wheel specs all correctly (check the config : MembersPage/PeepPaadam/AudiConfig )but no rpm signal. When i switch from multitooth to coil-type, it shows 100rpm every crank rotation like it should (one trigger event per rotation) but in multitooth mode...nothing. *Here is the trigger settings that is diffrent from my #HansK: **crank_minper=8B #50 **tooth_wheel_twidth1=02 #06 **tooth_wheel_twidth2=06 #12 **reset_engphase_after=F0 #FF Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.