######  
  ##  ## 
  ##  ## 
  #####  
  ##     
 ####    

 _     
( )    
| |    
| |  _ 
| |_( )
(____/'
       
       

 _____ 
|_   _|
  | |  
  | |  
 _| |_ 
 \___/ 
       
       

  _  __
 | |/ /
 | ' / 
 | . \ 
 |_|\_\
       

   ____ 
  / ___|
 | |  _ 
 | |_| |
  \____|
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi all! My project is an Aprilia RSV1000 dragbike. New Cams (320deg/11,5mm), bigger valves, headporting, 2 injector/port, 36-1 triggerwheel, wasted spark cop, E85 fuel, custom exhaust. It's working, not just in the head. '''Now I need wheel speed''' I wondered if i can use the senondary trigger lm1815 and vr for wheel speed. * yes. '''If sectrig is disabled, than you don't even need to disconnect the sec lm1815 from the CPU, can connect to ps2 clk directly''' ** but of course disconnecting from the CPU is very easy (unsolder the solderblob at the bottom under the injector FETs) ** [http://shop.vems.hu/catalog/hall-p-162.html VR to HALL] is also an option PG ---- '''Reported Dwell issue''' * The problem is around trigger settings ** The next trigger tooth and trigger reference tooth table is bad in your config ** Set the trigger as 8cyl engine and delay the first ignition 30 degree. ** The unused outputs need to assign different pins, so bigger dwell available ( measured 5ms at 10000 RPM) ** Bench tested [config http://www.vems.hu/files/MembersPage/PappGergely/ApriliaRSV1000/v2_60deg_36_1_bech_tested.vemscfg] worked for us, check the outputs and positions * The config has a lot of validation errors, always check and correct as much as possible
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.