_____ 
|  _  |
| | | |
| | | |
\ \_/ /
 \___/ 
       
       

    ###  
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  ###### 
         

         
         
 ##  ##  
 ##  ##  
 ######  
 ######  
 ##  ##  
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
vems 3.7 board vr/vr setup need changing over to vr/hall engine '''BMW m50b25tu ''' * '''primary trigger=VR''' 60-2 crank ** R30=18k (but 10k or 27k should also work). You probably do NOT want to change anything around primtrig, since primtrig=VR already (1k would be too strong anyway) * '''secondary trigger=HALL''' sensor on cam ** Changing to HALL should be simple, see GenBoard/Manual/InputTriggerHardWareSectrigHall ----------------------------------- bottom view https://drive.google.com/open?id=1eMa0XuRHrnh7cIYlCcI1ERID85F0nHxQ top view https://drive.google.com/open?id=1HEHAyxgnL-CFirkSctx10CqGjVuHbLED so i understand that the sj7 which is closed need to be opened about the other 5 holes i see there is a wire attached at another point on the board redwire on the bottom view do i just disconnect it ?? my image looks diff at this point https://drive.google.com/open?id=1WQ8ZMNXJSmv1sGjeOYzjHtMW9af0N-gW than this one http://www.vems.hu/manual/html/images/Testing/v3.6_sec_trigger_1_m.jpg thanks
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.