_   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

      ## 
  #####  
 ##  ##  
 #####   
  ##     
  #####  
 ##  ##  
 #####   

       
/'\_/`\
|     |
| (_) |
| | | |
(_) (_)
       
       

  _____ 
 | ____|
 |  _|  
 | |___ 
 |_____|
        

         
### ##   
 ### ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
vems 3.7 board vr/vr setup need changing over to vr/hall engine '''BMW m50b25tu ''' * '''primary trigger=VR''' 60-2 crank ** R30=18k (but 10k or 27k should also work). You probably do NOT want to change anything around primtrig, since primtrig=VR already (1k would be too strong anyway) * '''secondary trigger=HALL''' sensor on cam ** Changing to HALL should be simple, see GenBoard/Manual/InputTriggerHardWareSectrigHall ----------------------------------- bottom view https://drive.google.com/open?id=1eMa0XuRHrnh7cIYlCcI1ERID85F0nHxQ top view https://drive.google.com/open?id=1HEHAyxgnL-CFirkSctx10CqGjVuHbLED so i understand that the sj7 which is closed need to be opened about the other 5 holes i see there is a wire attached at another point on the board redwire on the bottom view do i just disconnect it ?? thanks
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.