_______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| (____/\
(_______/
         

  _    _ 
 | |  | |
 | |__| |
 |  __  |
 | |  | |
 |_|  |_|
         
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

  ______ 
 |  ____|
 | |__   
 |  __|  
 | |     
 |_|     
         
         

 ___   
(  _`\ 
| (_(_)
|  _)  
| |    
(_)    
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''1981 Volvo 242 DL''' http://oeb.xerc.biz/vems/DSC00020.jpg ---- The car is put together with mainly fabric new parts my dad had lying around in his workshop from his days tuning old Volvo's. * B21ET Turbo engine w/Mitsubishi TD04HL16-T turbo. * Volvo 940 Turbo intake manifold with Bosch 337 cc/min Low-Z injectors and Volvo 850 TPS. * Custom made triggerwheel with Honeywell 1GT101 same as [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FVolvoBtwenty this car] * Singe coil and distributor ignition, no cam sensor. * VEMS v3.3 firmware 1.0.38. http://oeb.xerc.biz/vems/DSC00258.jpg Trigger hits approx 65-70° after 0°. '''Trigger should give signal ~60 degrees _before_ tdc''' /Emil ---- '''Update 2006-11-17''' The car runs well with standalone ignition unit (Lumenition). '''When using VEMS ignition, I cant get the ignition over 0° while cranking.''' If I set "TDC after the trigger" lower than "2" my timinglight stops blinking. I tried 5-10-15 and 20 on "Priming, Cranking, Afterstart" - "Cranking advance" and still I get 0° on the timinglight. '''Could this be firmware related? (1.0.38)''' MSQ file [http://oeb.xerc.biz/vems/megasquirt200611162228.msq here] '''A:''' TDC after the trigger should be 65-70 if the trigger is mounted properly. if you have it at 65-70 after the trigger, your setting should be 110-115 degrees. Also make sure that ignition offset, under Extras , Advanced ALS is set to 0 degrees. A setting of 2degrees TDC after the trigger will make it impossible to have advance above 2 degrees.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.