##   
         
    ##   
    ##   
    ##   
    ##   
 ####    

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

         
         
 ### ##  
 #  #  # 
 #  #  # 
 #  #  # 
 #  #  # 
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| (____/\
(_______/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Audi 3.6 V8 NA engine, first time run in NA. In the future we will build up to the NA engine a GT35 turbocharger with low boost. We use the 3 factory Auditrigger. ---- Ordered items: 1 x LowZ extension 8 channel 1 x Alubos1600 1 x Alubos Motronic55 frontplate 1 x Alubos gasket 1 x Wideband O2 sensor 1 x Temperature sensor 1 x Coolant sensor AMP-connector 1 x 250kPa MAP sensor Model: MPX4250AP 9 x Injector or WBO2 heater driver 4 x Ignition driver 1 x Alubos Endplate - Drill-count: 2DSUB 1 x LCD4x20 - Color: green 1 x GenBoard v3.6 (unassembled) 1 x Idle stepper motor driver 1 x JPT55 connector ---- Econoseal-JPT55 (Vems-Motronic) converter pinout : http://www.vems.hu/files/Norbitron/V8t/VEMS-Motronic_V8_PT_pinout.xls Motronic pinout: http://www.vems.hu/files/Norbitron/V8t/v8%20kapcs1.png ---- EC36-4 (Tachometer) & EC36-25 1kOhm pullup connect (note: '''board has pads for 0805 SMD pullup resistor to +12V appr 3 mm from the EC36/4''', actually 1k pullup resistor marked "1001" is populated in factory so the throughole resistor is unnecessary) EC36-26 Sensor GND pin to EC36-5 onboard connect. http://www.vems.hu/files/Norbitron/V8t/boardwire1.jpg Auditrigger sensors shield(JPT-30pin. connect to LM1815 audisensor gnd. http://www.vems.hu/files/Norbitron/V8t/sensorgnd.jpg I connected the 5 GND to 1 dot with 15cm line. The dot (elágazik) to 4 line to JPT55- 10,14,19,24 pins. http://www.vems.hu/files/Norbitron/V8t/gndconnect.jpg http://www.vems.hu/files/Norbitron/V8t/vemsmotronic.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.