#### ### 
 ##   #  
 ##   #  
  ## #   
  ###    
   ##    
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 # ###   
 ##   #  
 #       
 #       
 #       
         

 ___   
(  _`\ 
| (_(_)
|  _)_ 
| (_( )
(____/'
       
       

 _   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
IMPORTANT: * '''I-button reader case must be GND''' (not +5V !!!) * '''the middle pin is EC18/pin16''' (that is OK). ** note: separate LED with series resistor (eg 270 Ohm) can be driven from p259 output (configure in Output/"Warning light") ** unfortunately the I-Button reader built-in LED is internally connected to GND, therefore cannot be driven from P259 output (that also pulls to GND) It's full original, rebuilt JN 9:1 NA 1.8 8V block with 2.0 ABK head with a TD04-15T turbo. I made a 100% new harness. Schematic diagram: http://www.vems.hu/files/Norbitron/8vtschematic.JPG Pinout: http://www.vems.hu/files/Norbitron/8vpinout.jpg '''Primary trigger''' * home-made 36-1 VR ** teeth gaps are appr 3-4mm ** very likely tooth before and after the missing tooth is much higher amplitude then other teeth ** unfortunately ECU was not ordered for poor-VR (R181 standard, not 270k). If pulses miss out (possibly only at higher RPM), remember this. Next time use HALL when making trigger at home. ---- * note: MembersPage/Norbitron/Audina/Quest is unrelated
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.