#####  
 ##  ##  
 ##      
 ##      
 ##   #  
  ####   
         

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| (____/\
(_______/
         

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| )      
|/       
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
MembersPage/NicolasGobet ------------------------------------- As I can see ATM128 is not powered, at least I don't have 3,3V between pin 1 and 2 (in fact, there is no voltage) Here is how pin are connected now: * to battery - ** EC36-pin5 ** EC36-pin21 ** EC36-pin26 ** EC36-pin32 * connected to battery + ** EC36-pin25 I'm not sure I have the good pin layout as I'm using the v3.1 board. Could someone confirm that? (especially for the EC36, as I don't have any power on the atmel processor). '''Q. I would really appreciate to know if I'm right with the battery + connected to EC36-pin25.''' As I can see, this pin doesn't go further on the board. I mean, there is no track from where I soldered the cable. '''A. Yes''', battery + (12V) should be connected to EC36-pin25, but see also the following link to see how to mount the power on board..//Hans// .. http://vems.hu/www.vems.co.uk/VEMS/ConnectingPower.html '''Thanks''' a lot, I'll try this. Bus as I can see on the picture on the page from phattransmission, my board has not the same components. Of the inductor between 1 and 2 and the fuse link between A and B are missing, but other components are not on my board. Do I have more components than the 2 to solder? (I'm not talking about coil/injector drivers) The inductor from Rescue kit1 marked 1R5 must be soldered Between A&B, and just a wire (short) betwen 1 and 2 if a fuse is mounted external. The inline diode and the voltageregulator (top-left corner of first pic) should bee mounted when you got the board. I think that is it, hope it helps. //Hans// using information from Hans (thanks again), I was able to get power to the atmel. * I can measure 4.5V between pin 1 and 2 of the atmel processor ** that's a bit low *** In fact this 4,95V, I simply forgot one number... ** what is supply voltage and current at the 12V supply ? *** It is 11,78V * voltage regulator is heating. Looks like board is powered now! Battery is ok
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.