_______ ( ____ \ | ( \/ | (_____ (_____ ) ) | /\____) | \_______)
### ## ##### ## ## ##
__ __ \ \ / / \ \ /\ / / \ \/ \/ / \ /\ / \/ \/
## ## ## ## ## ## ##### ## #####
_____ / ____| | (___ \___ \ ____) | |_____/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: * MembersPage/NanassyPeter/TriggerSetup for trigger related pins '''Very important pins - if they get disconnected, the ECM will be damaged''': '''GND5''' (power-GND) * EC36pin26 (signal GND, not power) * EC36pin22 (next to flyback; custom) * EC36pin21 * EC36pin5 * EC36pin32 1 .. 1.5mm2 wires recommended for all GND (and GND5) signals and ignition output(s). 0.5 .. 0.75 .. 1 mm2 wires recommended for other signals. '''Flyback''' (injector common +supply) * EC36pin23 ---- '''RS232''' - EC18 connection, as on GenBoard/Manual/CommHardware * EC18pin14 DSUB9-pin3 * EC18pin15 DSUB9-pin2 DSUB9-pin5 Ground,but where to connect?? Connect to sensor ground, EC36-26. Other grounds have lots of noise on them from injectors and IGBT's switching on and off. ---- '''Knock''' - initally left open * EC18pin3 : knock signal * EC18pin2 : knock GND (same as EC36pin26) ---- Question: Sensor ground: *The CLT,MAT sensors have 2 pins,one goes to a dedicated ECU pin (CLT 36/14, MAT 36/2), but what to do with the other pin? Other pin is ground (EC36-26). Since these are resistive sensors, using either pin will work. *DSUB9-pin5 Ground,but where to connect?? *'''Very important pins - if they get disconnected, the ECM will be damaged''': '''GND''' to battery negative, and sensors and shields for shielded wires * EC36pin26 (signal GND) '''GND5''' (power-GND) All GND5 must go to battery negative. Use separate wires for each, and make sure some remains connected in any case (even if some breaks or something!) * EC36pin22 (next to flyback; custom) * EC36pin21 * EC36pin5 * EC36pin32 TODO: please document other connections before powering up the unit Also read through the manual. The manual will explain the wiring and other issues. After reading the manual, read it again; there is a lot of information inside. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.